tag:blogger.com,1999:blog-11904671.post4900957424904085791..comments2023-08-25T03:21:41.842-07:00Comments on The Petch House: The Spinning Blade of DeathGreghttp://www.blogger.com/profile/02807710209656158413noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-11904671.post-91726722194574899242008-07-25T07:20:00.000-07:002008-07-25T07:20:00.000-07:00Good stuff that. Very nice job. Lots of dust.Good stuff that. Very nice job. Lots of dust.STAGhttps://www.blogger.com/profile/06198646624631167489noreply@blogger.comtag:blogger.com,1999:blog-11904671.post-58579862179494834632008-07-22T12:49:00.000-07:002008-07-22T12:49:00.000-07:00Good call on the hard to clean :)Good call on the hard to clean :)Alhttps://www.blogger.com/profile/06012721900260853690noreply@blogger.comtag:blogger.com,1999:blog-11904671.post-70058942060647813092008-07-22T12:43:00.000-07:002008-07-22T12:43:00.000-07:00Nick,I went full speed. At first I was going to do...Nick,<BR/><BR/>I went full speed. At first I was going to do it in two passes. First do a partial cut and then the full depth. Maybe when the bit is a little older and not as sharp I would do that.<BR/><BR/>Al,<BR/><BR/>I went back and forth on that. If I centered it, I would have a 4-inch gap on the left. There is another cabinet that goes underneath it that is the same width. It just seemed like wasted space and one more place for things to get lost in, and some place that is hard to clean.Greghttps://www.blogger.com/profile/02807710209656158413noreply@blogger.comtag:blogger.com,1999:blog-11904671.post-32314666733052985982008-07-22T10:53:00.000-07:002008-07-22T10:53:00.000-07:00I can't help it... I have to ask... Is there a rea...I can't help it... I have to ask... Is there a reason you didn't center the cabinet on that wall? Sorry, my anal retentive nature is kicking in.<BR/><BR/>I'm glad your doors are finally done. I can't WAIT to see the painted finished product!Alhttps://www.blogger.com/profile/06012721900260853690noreply@blogger.comtag:blogger.com,1999:blog-11904671.post-8736749857819643962008-07-22T08:32:00.000-07:002008-07-22T08:32:00.000-07:00Neato.I haven't used a large panel bit like that b...Neato.<BR/><BR/>I haven't used a large panel bit like that before. But I hear that you need to adjust the speed to be lower - did you do that and how did it work?Unknownhttps://www.blogger.com/profile/03312743157083046153noreply@blogger.com