Rectangle Amoebas

I got the 4 drawer fronts assembled today. They came out pretty good and the size is good, but it would be better if they were an inch-wider. They ended up being 4.75X17 inches. Because I split the amoebae shaped burl slab I ended up with 2 pairs of book matched drawer fronts. Pretty cool.







As you may recall, I’m putting the tiled panel in an inset in the center. The tiles are 5.75-inches wide and the wood surrounding them will be about 2.5-inches on either side. I’ll loose a little in the tile width when they are set, so I’m looking at 10.5-inches of visible face for the panel section.

The over-all space for the cabinets is 99-inches wide. Subtract the 10.5 inches for the tile section and I’m left with 88.5-inches. Divide that by 2 and I get 2, 44.25-inch sections on either side of the tile panel. Two 17-inch wide drawers in one section makes 34-inches. Plus 2.75-inch stiles on either side, and one in the middle, makes another 8.25-inches. Thirty-four plus 8.25 makes 42.25-inches. That means I need to fill 2-inches for each section, or 4-inches over-all. That’s a lot.

Some of that will be taken up by gaps around the drawers. Four drawers with an eighth-inch gap on either side makes an inch. Also, the casing that will cover the gap between the wall and the cabinet needs to be in a fairly precise location because of the trim on the raised panel dado. There is about an inch on either side I can play with, but no more than that. Let’s say and inch and a half over-all – 3/4 of an inch on either side . An inch for the drawers, plus an inch and a half at the casing, make 2.5-inches. I still need to make up and inch and a half.

I think what I’ll do is make the 2 face frames for the section on either side of the tile panel and then re-evaluate the width. It would be nice if I could just make the outside stiles of the two face frames with 6-inch wide material and then trim the whole thing to fit once it is assembled. Because I’m using all of the curly redwood I milled out of the 2 big slabs I can’t do that. The widest pieces I’m going to end up with will be 3-inches, and most will be 2.75-inches.

Its going to be close.