ListWise

Tuesday, June 02, 2009

Shwing! Marble’s Here!

There was a message on the machine last night when I got home, but it was too late to contact them. At 10:00 this morning I got a call saying it was on the truck and ready to go. I met them at the house about 10 minutes later. Installation took them all of 5 minutes because it was pretty much just drop it in to place.



I had them leave it hanging about 6 inches off the edge so there was room for the router.



It is pretty much just a rough, saw cut edge when I get it, so the first thing to do is run the router over it.



The router bit has a bearing on the bottom that rides along the edge as the blade cuts. This ensures a even depth of cut. In the kitchen I did a quarter inch round-over and was able to do it in one pass. This time I went with a 5/8th inch round-over and it took several passes. Note the vacuum hose on the router. This is am absolute must.

The first couple of feet were very nerve-wracking. After a few minutes though, I got in to a groove and it went quickly. I would work on about a 1-foot section at a time and keep running the router over it until the bearing bottomed out.



Here is what I’m left with. From here I’ll work on it with the random orbital sander, starting out with 100 grit and working my to at least 300. I’ll probably finish it up by hand with some 600 grit wet/dry sandpaper and then polish it out. It is just the edge, so doesn’t take too long.

As it turns out, the slab they ended up getting was over 9-feet long. Even they couldn’t explain it. What this means is that there was no need for me to shorten the width of the middle section. I brought the sides in 3-inches on either side so it would be less than 8-feet. Not much I can do about it now.

Because I bought the whole slab they have a huge piece left over. Originally, the plan was to store it in the garage, but based on the size of the “remnant” (There is more left-over than I used) they talked me in to leaving it in their yard. I think I have a plan for it, but more on that later.

1 comment:

Shane said...

Looking good!